RE: [CAD_CAM_EDM_DRO] Power enough?

> -----Original Message-----
> Hi,
>
> I've come across a number of step motors with the following
> specs: 100 oz/in holding torque 200 steps per rev. 1.65Vdc @ 4.7A
>
> Now, I would like to use these to convert my lathe (standard 9x20)
> and mill (WABECO 1200) to CNC. I fear that the 100oz/in is a little
> on the low side - can any of you enlighten me on this?
>
> best regards
> Peter
> FAQ: http://www.ktmarketing.com/faq.html

Peter,

100 oz/in is consider on the low end for a Sherline or Taig table top
mill. For anything larger they will be inadequate. The specs seem like
they would be great for something small as they seem to be very low
inductance so they will have nice high speed characteristics.

Tim
[Denver, CO]
Sherline products at Deep Discount
Mach1 & DeskCNC with credit card ordering
www.KTMarketing.com/Sherline