RE: [CAD_CAM_EDM_DRO] Carving airplane propellers
Posted by
Tim Goldstein
on 2003-06-06 14:25:24 UTC
Fred has a nice tutorial using Vector Nurbs on drawing a propeller. It
is on his support forum at www.imsrv.com/discus under the 3-D &
surfacing section.
Tim
[Denver, CO]
Sherline products at Deep Discount
Mach1 & DeskCNC with credit card ordering
www.KTMarketing.com/Sherline
is on his support forum at www.imsrv.com/discus under the 3-D &
surfacing section.
Tim
[Denver, CO]
Sherline products at Deep Discount
Mach1 & DeskCNC with credit card ordering
www.KTMarketing.com/Sherline
Discussion Thread
Andrew Werby
2003-06-06 13:23:21 UTC
Carving airplane propellers
Tim Goldstein
2003-06-06 14:25:24 UTC
RE: [CAD_CAM_EDM_DRO] Carving airplane propellers