Re: stepper/module
Posted by
funcadem
on 2003-06-07 19:51:41 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "motorworksnf"
<motorworksnf@y...> wrote:
Looks like Mariss got a compeititor.
run unipolar hybrid PM step motors with current ratings from 0.75 to
7 amps per phase.
control interface ... is opto-isolated...
.... compatible with TTL drivers....
... power supply between 24 - 60 VDC
... never bundle the motor leads in the same cable as the STEP and
DIRECTION input leads.
Plus Mariss has the possibility to improve his sure-footed Geckos
further. Thought I read that the drivers can progress from 1/2
stepping at low speed to full stepping at high speed.
Fun
<motorworksnf@y...> wrote:
> Hiand
> I was wondering about this module drive.I am building a cnc lathe
> my question is can I use this Centent CNO153 like a gecko in myHi Eddie,
> system.i.e. Use it to drive the stepper via the computor?Hope it's
> clear ,that is what I am trying to ask,Still learing!!More info on
> this link:
> http://www.centent.com/cn0152.htm
> eddie
Looks like Mariss got a compeititor.
run unipolar hybrid PM step motors with current ratings from 0.75 to
7 amps per phase.
control interface ... is opto-isolated...
.... compatible with TTL drivers....
... power supply between 24 - 60 VDC
... never bundle the motor leads in the same cable as the STEP and
DIRECTION input leads.
Plus Mariss has the possibility to improve his sure-footed Geckos
further. Thought I read that the drivers can progress from 1/2
stepping at low speed to full stepping at high speed.
Fun
Discussion Thread
motorworksnf
2003-06-07 18:12:40 UTC
stepper/module
funcadem
2003-06-07 19:51:41 UTC
Re: stepper/module