Re: [CAD_CAM_EDM_DRO] Re: AMAZING STUFF!

All help is welcome. If there is software out there it can come from any source. It wouldn't hurt to look.

----- Original Message -----
From: Ken Lowther
To: CAD_CAM_EDM_DRO@onelist.com
Sent: Sunday, March 12, 2000 11:30 PM
Subject: Re: [CAD_CAM_EDM_DRO] Re: AMAZING STUFF!


From: Ken Lowther <lowther@...>

james owens wrote:
>
> From: "james owens" <wotisname@...>
>
> My intention to hookup DRO and use it as positional information came about because I have a warn lead-screw on my Bridgeport type milling machine. The cost of replacing the past it parts would be far inexcess $600 greater than the machines worth. I decided to start at the end and look around for software that could use this type of input, none was found. It seems that the whole thing is turning into a nightmare with every part of the project being developed from scratch. With hind-sight it would have been far cheaper to buy a new machine but I thought that there must be people out there that would have a use for such a system and have carried on. It will be done. I will keep you posted as to the results, good or bad.

I am just getting some machine tools together myself. The guy working
on "Stepster" is well aware of this kind of thing from telescope
making. I can point you to telescope softeware if you want. I can do
some coding, but not really one of my strenghts.

--
Ken Lowther
Youngstown, Ohio
http://www.atmsite.org
ATM FAQ and more
Good starting place for amateur telescope makers

------------------------------------------------------------------------------



------------------------------------------------------------------------------
Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems in the above catagories.
To Unsubscribe, read archives, change to or from digest.
Go to: http://www.onelist.com/isregistered.cgi
Log on, and you will go to Member Center, and you can make changes there.
For the FAQ, go to http://www.ktmarketing.com/faq.html
bill,
List Manager



[Non-text portions of this message have been removed]