blade holder (was vinyl cutting..)

Any pictures of the inside or is that a trade secret ;-)?
+Stan

-----Original Message-----
From: CAD_CAM_EDM_DRO@yahoogroups.com [SMTP:CAD_CAM_EDM_DRO@yahoogroups.com]
Sent: Thursday, July 17, 2003 11:38 AM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Digest Number 3240


Message: 2
Date: Thu, 17 Jul 2003 09:26:20 -0000
From: "rainnea" <rainnea@...>
Subject: Re: Vinyl Cutting Algorithms

Forgot to add,
I put some pictures of the vinyl-cutter holding attatchment I made
for my router in the photos section of the CNC Toolkit forum;
http://photos.groups.yahoo.com/group/CNC_Toolkit/lst

Regards,
Rab


--- In CAD_CAM_EDM_DRO@yahoogroups.com, "fortino" <fortino_tan@h...>
wrote:

> Rab,
> Typically, the blade is not centered. It is offset about 0.1-0.2 mm

from the

> center.
> This offset would allow the knife to swivel/ turn every time it

changes

> direction.
> Beside, how about your knife? do you buy it or make it by yourself?
>
> I have two vinyl cutting machine that was driven by Gecko. The

mechanical

> part
> was build using chinese brand vinyl cutting machine. It uses

stepper motor.

>
> fortino
>