Re: I'm New here
Posted by
PTENGIN@x...
on 1999-05-09 04:05:26 UTC
In a message dated 5/8/99 8:22:10 PM Hawaiian Standard Time, pencad@...
writes:
<< Now, my project I want to do I to assemble a laser
cutter of approx. 40-50 watts, CO2 powered laser. >>
Hello folks. Peter Tsukamoto here. I have just joined and am most impressed
with the potential of this group. I look forward to reading the posts
everyday.
In regards to the laser project Don is attempting, my only input would be to
use extreme caution around a laser processing machine. If any of the laser
energy inadvertently got directed into a persons eyes, that would be the end
of that persons vision. I doubt the laser goggles sold by the laser makers
would be enough to prevent damage. At the very least, a visit to a metal shop
that has a metal cutting laser and observing the shielding techniques would
be warranted. Peter
writes:
<< Now, my project I want to do I to assemble a laser
cutter of approx. 40-50 watts, CO2 powered laser. >>
Hello folks. Peter Tsukamoto here. I have just joined and am most impressed
with the potential of this group. I look forward to reading the posts
everyday.
In regards to the laser project Don is attempting, my only input would be to
use extreme caution around a laser processing machine. If any of the laser
energy inadvertently got directed into a persons eyes, that would be the end
of that persons vision. I doubt the laser goggles sold by the laser makers
would be enough to prevent damage. At the very least, a visit to a metal shop
that has a metal cutting laser and observing the shielding techniques would
be warranted. Peter
Discussion Thread
Don Hughes
1999-05-08 23:21:02 UTC
I'm New here
PTENGIN@x...
1999-05-09 04:05:26 UTC
Re: I'm New here
Don Hughes
1999-05-10 22:10:02 UTC
Re: I'm New here