CAD CAM EDM DRO - Yahoo Group Archive

Re: My power supply calculations - Light Comes On

Posted by jeffalanp
on 2003-09-06 12:00:16 UTC
Hi,
The 3977 will limit the current for you. You really wouldn't end
up with glowing motors (assuming the current reference adjustment was
set properly fro the motor), just an oversized supply.

Jeff

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "ghidera2000"
<ghidera2000@y...> wrote:

> If I had 5 volt 3 amp steppers thats only 15 watts. When I increase
> the voltage to 30, I still have to keep the actual power the same
or
> I have glowing/molton motors - so thats only 1/2 amp at 30 volts,
> not 3 amps at 30. Total power supply required for 4 axis would only
> be 2 amps, not 12...

Discussion Thread

ghidera2000 2003-09-06 10:15:56 UTC My power supply calculations and a zener question turbulatordude 2003-09-06 10:32:01 UTC Re: My power supply calculations and a zener question Bernard R 2003-09-06 10:41:41 UTC Re: My power supply calculations and a zener question ghidera2000 2003-09-06 10:44:20 UTC Re: My power supply calculations and a zener question Tim Goldstein 2003-09-06 10:48:47 UTC RE: [CAD_CAM_EDM_DRO] My power supply calculations and a zener question turbulatordude 2003-09-06 11:15:23 UTC Re: My power supply calculations and a zener question ghidera2000 2003-09-06 11:42:38 UTC Re: My power supply calculations - Light Comes On ghidera2000 2003-09-06 11:47:42 UTC Re: My power supply calculations and a zener question jeffalanp 2003-09-06 12:00:16 UTC Re: My power supply calculations - Light Comes On Chris Baugher 2003-09-06 12:34:12 UTC Re: [CAD_CAM_EDM_DRO] Re: My power supply calculations - Light Comes On ghidera2000 2003-09-06 12:40:03 UTC Re: My power supply calculations - Light Comes On turbulatordude 2003-09-06 14:03:17 UTC Re: My power supply calculations - Light Comes On ghidera2000 2003-09-06 16:56:32 UTC Re: My power supply calculations - Light Comes On ghidera2000 2003-09-06 16:58:46 UTC Re: My power supply calculations - Light Comes On turbulatordude 2003-09-06 19:34:16 UTC Re: My power supply calculations - Light Comes On