Re: [CAD_CAM_EDM_DRO] Bobcad And RHino?
Posted by
ptengin@a...
on 2000-03-22 02:02:09 UTC
In a message dated 03/21/2000 3:03:46 AM Hawaiian Standard Time,
imserv@... writes:
<< This program will generate
cross-sectional slices in any 2 normally oriented planes, through complex
Nurb Curve based surfaces (like Rhino generates). >>
Fred,
Can I throw one at you since you mentioned Rhino? I'd like to know if
there is a way to save a Rhino drawing to a DXF file that Bobcad will
understand. I tried various ways but always get the triangular facets that
make cutting the resulting file very tough. Is there a program similar to
IGES2DXF for the .3DM files? Though I have done little with Rhino, it is
very easy to use. Now if only I could cut from it.
Peter
THRD, Inc.
imserv@... writes:
<< This program will generate
cross-sectional slices in any 2 normally oriented planes, through complex
Nurb Curve based surfaces (like Rhino generates). >>
Fred,
Can I throw one at you since you mentioned Rhino? I'd like to know if
there is a way to save a Rhino drawing to a DXF file that Bobcad will
understand. I tried various ways but always get the triangular facets that
make cutting the resulting file very tough. Is there a program similar to
IGES2DXF for the .3DM files? Though I have done little with Rhino, it is
very easy to use. Now if only I could cut from it.
Peter
THRD, Inc.