Can I use power supply from computer.
Posted by
Neil
on 2003-09-07 19:33:57 UTC
I have an old power supply from a computer.
I'd like to use it to power my controller/driver board.
The supply: typical disk drive power supplies.
Two mother board suppies.
Controller board: The instructions indicate that I need 5v/ 300ma +/-
.25v.
Each motor axis can take from 0 to 24v
Is this doable?
I'd like to use it to power my controller/driver board.
The supply: typical disk drive power supplies.
Two mother board suppies.
Controller board: The instructions indicate that I need 5v/ 300ma +/-
.25v.
Each motor axis can take from 0 to 24v
Is this doable?