Software to operate plasma table
Posted by
oakberk
on 2003-09-10 19:32:06 UTC
I am nearing completion on a plasma table and am seeking advice on
what software to choose to run it. A friend recently showed me a demo
video from PlasmaCam. It sure looks easy! Advertising being what it
is...
I have also looked at SuperCam which is dos based and seems to require
several distinct steps to get to a finished part. I do understand that
Mach2 can have a THC circuit built especially for it. I would like
something that a novice can grasp fairly quickly. What do experienced
users say? The software outlay being what it is I really don't want
to make a mistake. Thanks to all of you I have learned more about cnc
than I would have thought possible. Great group!
what software to choose to run it. A friend recently showed me a demo
video from PlasmaCam. It sure looks easy! Advertising being what it
is...
I have also looked at SuperCam which is dos based and seems to require
several distinct steps to get to a finished part. I do understand that
Mach2 can have a THC circuit built especially for it. I would like
something that a novice can grasp fairly quickly. What do experienced
users say? The software outlay being what it is I really don't want
to make a mistake. Thanks to all of you I have learned more about cnc
than I would have thought possible. Great group!
Discussion Thread
oakberk
2003-09-10 19:32:06 UTC
Software to operate plasma table
stevenson_engineers
2003-09-11 00:37:03 UTC
Re: Software to operate plasma table