CAD CAM EDM DRO - Yahoo Group Archive

RE: RE: Re: Power supply transformer setup questions...Capa...

Posted by Lloyd Leung
on 2003-09-10 21:16:25 UTC
Jan,

Reading http://www.geckodrives.com/ycom/documents/C163R16_power_supplies.pdf
page 2, last paragraph.

From what I read, I interpret it as, 2/3rd or 1/3rd the motor amperage sum
(for half or full winding). See first page, paragraph 2.

Let me know what you think it is.

Lloyd


-----Original Message-----
From: JanRwl@... [mailto:JanRwl@...]
Sent: September 10, 2003 11:00 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: Re: RE: Re: Power supply transformer setup questions...Capa...

In a message dated 9/10/2003 9:56:54 PM Central Standard Time,
lloyd@... writes:

> That is VDC from the power supply?
> Current (I) is the amperage sum of the motors * 2/3rds?


Lloyd: Yes on VDC. The "I" is current, but I am not sure if the "2/3"
applies, here. Mariss will probably clear this up when he gets back from
the
Bahamas.

Discussion Thread

JanRwl@A... 2003-09-10 20:00:35 UTC Re: [CAD_CAM_EDM_DRO] RE: Re: Power supply transformer setup questions...Capa... Lloyd Leung 2003-09-10 21:16:25 UTC RE: RE: Re: Power supply transformer setup questions...Capa... turbulatordude 2003-09-10 21:46:27 UTC Re: Power supply transformer setup questions...Capa... Mariss Freimanis 2003-09-11 10:58:13 UTC Re: Power supply transformer setup questions...Capa... turbulatordude 2003-09-12 08:09:27 UTC Re: Power supply transformer setup questions...Capa... Mariss Freimanis 2003-09-12 09:42:58 UTC Re: Power supply transformer setup questions...Capa...