Dos Computer help needed

I am setting up TrublCNC, using Xylotex drives. Sherline Lathe, and Sherline
Mill.
200 step /rev Steppers, 20 TPI, lead screw.

It has been about ten years since I have even looked at DOS, so most
knowledge is long gone, thus my need of help.

I would very much like a copy of the following from a DOS computer, using the
above setup:
Autoexec.bat
Config.sys

Also from someone using the same Sherline, Xylotex, TurboCNC system, I would
like very much to have a copy of your TURBOCNC.INI file, for either a lathe,
or a mill setup, or both. This would be appreciated, and help me to run it
tomorrow.
If you can just copy and Email anything you can to help me. Wanliker at AOL
dot com


I have the Computer running and TurboCNC, running, and most of the .INI set
up, but would like to double check against a similar running system.
DOS 6.22, and TurboCNC, are the only programs on it. The CPU is an AMD
-2-2/350 CPU
65 Megs memory, if I read it right.
Everything is waiting on finishing setup, and a printer cable.
Cross posted to other groups, but don't let that stop you, I am really a bit
desperate.....
Thanks,
bill
CCED
wanliker at AOL dot com



[Non-text portions of this message have been removed]