Re: [CAD_CAM_EDM_DRO]

I think that everyone from time to time wishes the cost of software was not so high and there is always some people who will want to turn to hacked products. We should always search out ways to protect our ideas and the fruits of our labour from the pirate but it is a little harsh for us to banish those who ask the question, just don't encourage them.

Terry.

----- Original Message -----
From: Paul Devey
To: CAD_CAM_EDM_DRO@onelist.com
Sent: Thursday, March 30, 2000 3:46 PM
Subject: Re: [CAD_CAM_EDM_DRO]


I do not see our group as participating in this type of behaviour, but, give
him another chance.

Paul Devey

----- Original Message -----
From: Dan Falck <dfalck@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Thursday, March 30, 2000 12:49 AM
Subject: Re: [CAD_CAM_EDM_DRO]


> From: Dan Falck <dfalck@...>
>
> At 03:10 PM 3/30/00 +1000, you wrote:
> >From: "shaun williams" <shaun_chris@...>
> >
> >i am looking for a copy of surfcam ver. 7.1 or later, which has been
cracked
> >or just a crack for 7.1 does anyone know where i might find this?
> >thanks
> >
>
> This isn't the group for you! Bill, get rid of this guy!
>
> Dan
>
>
> ------------------------------------------------------------------------
> Get a NextCard Visa, in 30 seconds!
> 1. Fill in the brief application
> 2. Receive approval decision within 30 seconds
> 3. Get rates as low as 2.9% Intro or 9.9% Fixed APR
> Apply NOW!
> http://click.egroups.com/1/2646/2/_/423600/_/954394420/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>


------------------------------------------------------------------------------



------------------------------------------------------------------------------
Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems in the above catagories.
To Unsubscribe, read archives, change to or from digest.
Go to: http://www.onelist.com/isregistered.cgi
Log on, and you will go to Member Center, and you can make changes there.
For the FAQ, go to http://www.ktmarketing.com/faq.html
bill,
List Manager



[Non-text portions of this message have been removed]