Re: EMC to be used with MasterCam or ProE [asimtec]
Posted by
Asim Khan
on 2003-11-26 20:50:58 UTC
Hi jd! i am on holidays as soon as i join back i'd get the code that
produced these strange moves.
I dont have much knowledge about generating programs out of mastercam
or pro-e. i'd really be thankfull if someone tells me:
1. steps needed to generate programs using mastercam or pro-e
2. are there any non supported g-codes that must be not used?
and i would like to know how most people use Enhanced Machine
Controller (EMC) to run their milling machines. Do they mostly
generate programs by manual coding or do they use automated tools
found in cad softwares, to generate tool paths ?
If someone could reccomend any such software?
regards
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "John Delaney"
<john.p.delaney@v...> wrote:
produced these strange moves.
I dont have much knowledge about generating programs out of mastercam
or pro-e. i'd really be thankfull if someone tells me:
1. steps needed to generate programs using mastercam or pro-e
2. are there any non supported g-codes that must be not used?
and i would like to know how most people use Enhanced Machine
Controller (EMC) to run their milling machines. Do they mostly
generate programs by manual coding or do they use automated tools
found in cad softwares, to generate tool paths ?
If someone could reccomend any such software?
regards
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "John Delaney"
<john.p.delaney@v...> wrote:
> OK, well I'm really new to this but my gut reaction is to golooking
> for lines of G-code that are making it do that and delete / change
> them.
>
> Or is it possible to tweak your drawing and thus tweak the output?
> Just a thought.
>
> Or you could just write it off as a "personality trait" :-)
>
> Thanks,
> -jd
Discussion Thread
Asim Khan
2003-11-26 03:15:41 UTC
EMC to be used with MasterCam or ProE [asimtec]
John Delaney
2003-11-26 06:55:23 UTC
Re: EMC to be used with MasterCam or ProE [asimtec]
Asim Khan
2003-11-26 20:50:58 UTC
Re: EMC to be used with MasterCam or ProE [asimtec]
Ray Henry
2003-11-27 06:07:09 UTC
Re: Re: EMC to be used with MasterCam or ProE [asimtec]
Ray Henry
2003-11-27 06:21:10 UTC
Re: Re: EMC to be used with MasterCam or ProE [asimtec]
Kim Lux
2003-11-27 12:47:52 UTC
John P Delaney
John Delaney
2003-11-28 18:55:05 UTC
Re: John P Delaney