Re: [CAD_CAM_EDM_DRO] Re: Hexapod ball joints, Moglice
Posted by
Jon Elson
on 2003-12-19 09:56:37 UTC
Graham Stabler wrote:
will be likely to pop out. I can imagine pouring the Moglice in two
parts, letting the first part harden and then putting mold release agent
on it before casting the 2nd part. It would be tricky to get the Moglice
to just the right height. Or, you could have a very thin divider made of
shim stock, perhaps, that would allow the unit to split on the diameter
of the ball. Put mold release on the divider. It might be possible to make
the thing like a collet holder. There'd be a back half, with a half-ball
Moglice casting. And, a front half that screws on, with a Moglice ring to
support the ball from the front. You could screw the front ring on tighter
to adjust as the Moglice wears.
Jon
>Actually I don't seem to have permission to upload files so pleaseI think you need to have the Moglice surround the ball more, or it
>see the diagram here:
>
>www.indoor.flyer.co.uk/ball.jpg
>
>
will be likely to pop out. I can imagine pouring the Moglice in two
parts, letting the first part harden and then putting mold release agent
on it before casting the 2nd part. It would be tricky to get the Moglice
to just the right height. Or, you could have a very thin divider made of
shim stock, perhaps, that would allow the unit to split on the diameter
of the ball. Put mold release on the divider. It might be possible to make
the thing like a collet holder. There'd be a back half, with a half-ball
Moglice casting. And, a front half that screws on, with a Moglice ring to
support the ball from the front. You could screw the front ring on tighter
to adjust as the Moglice wears.
Jon
Discussion Thread
Graham Stabler
2003-12-18 15:14:13 UTC
Hexapod ball joints, Moglice
Jon Elson
2003-12-18 22:06:43 UTC
Re: [CAD_CAM_EDM_DRO] Hexapod ball joints, Moglice
Graham Stabler
2003-12-19 06:25:04 UTC
Re: Hexapod ball joints, Moglice
Graham Stabler
2003-12-19 06:29:52 UTC
Re: Hexapod ball joints, Moglice
Marcus and Eva
2003-12-19 07:48:08 UTC
Re: [CAD_CAM_EDM_DRO] Hexapod ball joints, Moglice
Marcus and Eva
2003-12-19 08:08:42 UTC
Re: [CAD_CAM_EDM_DRO] Re: Hexapod ball joints, Moglice
Graham Stabler
2003-12-19 09:17:35 UTC
Re: Hexapod ball joints, Moglice
Jon Elson
2003-12-19 09:56:37 UTC
Re: [CAD_CAM_EDM_DRO] Re: Hexapod ball joints, Moglice