CNC MSComm flow control
Posted by
Bill Yates
on 2004-01-05 09:54:39 UTC
Hello
I am trying to flatten some of the grey areas before starting my new
CNC controller project.
Does anyone know if software handshaking (XOn/XOff) works with the
Microsoft MSComm control when it is configured to text mode as
opposed to binary mode?
Regards
Bill
I am trying to flatten some of the grey areas before starting my new
CNC controller project.
Does anyone know if software handshaking (XOn/XOff) works with the
Microsoft MSComm control when it is configured to text mode as
opposed to binary mode?
Regards
Bill
Discussion Thread
Bill Yates
2004-01-05 09:54:39 UTC
CNC MSComm flow control
Les Newell
2004-01-05 10:28:22 UTC
Re: [CAD_CAM_EDM_DRO] CNC MSComm flow control
Berg, Bob
2004-01-05 11:19:19 UTC
RE: [CAD_CAM_EDM_DRO] CNC MSComm flow control
Kim Lux
2004-01-05 11:19:45 UTC
Re: [CAD_CAM_EDM_DRO] CNC MSComm flow control
Bill Yates
2004-01-07 09:38:53 UTC
Re: CNC MSComm flow control