Re: [CAD_CAM_EDM_DRO] PA8000 Linux based CNC
Posted by
William Scalione
on 2004-01-18 23:33:02 UTC
Looks nice, but if they don't respond to emails from a potential customer, I
would be a little hesitant to buy from them. What happens if you need
support, and they still don't respond to emails?
Bill
would be a little hesitant to buy from them. What happens if you need
support, and they still don't respond to emails?
Bill
> Has anyone looked at this control? It touts that it can handle Sink EDM.2nd
> They have models from 4 axis Linux to 32 axis NT. I've followed their ads
> for a couple years and finally they say they can 'do' EDM. For the 1st
> year they didnt respond to emails asking if it could 'do EDM', then the
> year, they had a small picture of Erowa tooling EDMing in oil, but didnt
> respond to email questions. Now they state the ability specificly.
>
> http://www.low-cost-cnc.com/
>
> The tech manuals were always impressive (seems to have hypothetical axis,
> aka 'tilt' ).
>
> They're from Germany, but have an agent in Madison Wisconsin.
>
> regards
> tomp
Discussion Thread
ja_erickson
2004-01-18 16:28:52 UTC
VFD? - Brodgeport retrofit questions
Peter Renolds
2004-01-18 17:47:30 UTC
Re: [CAD_CAM_EDM_DRO] VFD? - Bridgeport retrofit questions
tomp_tag
2004-01-18 22:25:28 UTC
PA8000 Linux based CNC
William Scalione
2004-01-18 23:33:02 UTC
Re: [CAD_CAM_EDM_DRO] PA8000 Linux based CNC
Bob McKnight
2004-01-18 23:52:43 UTC
Re: [CAD_CAM_EDM_DRO] Allen Bradley 1336
Jon Elson
2004-01-19 10:32:17 UTC
Re: [CAD_CAM_EDM_DRO] PA8000 Linux based CNC
Bob McKnight
2004-01-19 13:37:23 UTC
Re: [CAD_CAM_EDM_DRO] Allen Bradley 1336
tomp_tag
2004-01-19 21:30:46 UTC
Re: [CAD_CAM_EDM_DRO] PA8000 Linux based CNC