Re: [CAD_CAM_EDM_DRO] bill's thoughts, serpentine? linefeeds?
Posted by
Jim Register
on 2000-04-09 14:55:31 UTC
At 12:43 PM 4/9/2000 -0700, you wrote:
related to machining. However, because of its wide appeal, the
traffic is more than I am able to keep up with and get anything done.
The egroup is getting busier all the time, and as it is a mailing list
rather than a newsgroup, the conversations don't thread and are becoming
more difficult to follow. Widening the charter would probably make it
entirely unmanageable. My vote is to leave it the way it is.
Jim
>RCM provides that wide interest base. This is a newsgroup forI agree - the rec.crafts.metalworking newsgroup includes most topics
>a special niche group. It is PERFECT the way it is. Bill is doing
>a fine job, and at times that is very hard to do.
>
>Steve
related to machining. However, because of its wide appeal, the
traffic is more than I am able to keep up with and get anything done.
The egroup is getting busier all the time, and as it is a mailing list
rather than a newsgroup, the conversations don't thread and are becoming
more difficult to follow. Widening the charter would probably make it
entirely unmanageable. My vote is to leave it the way it is.
Jim
Discussion Thread
Steve Carlisle
2000-04-09 12:37:50 UTC
Re: [CAD_CAM_EDM_DRO] bill's thoughts, serpentine? linefeeds?
Jim Register
2000-04-09 14:55:31 UTC
Re: [CAD_CAM_EDM_DRO] bill's thoughts, serpentine? linefeeds?