Re: [CAD_CAM_EDM_DRO] Toshiba DC Brushless Servo Drives

Brad Eyben wrote:

>I have 3 Toshiba RA12 Brushless servo motors
> 1 Toshiba 170V DC power supply
>and 3 Toshiba RA Drivers
>
>My problem is this, I'm unable to find any manuals or support anywhere for these drives and don't know how I might find out how to hook this up.
>There is a picture here.
>http://www.imagestation.com/album/?id=4287897323
>I know the screw terminals are power in to the drive from the supply and power out to the motors.
>The Blue 20 pin connector goes to the motor encoders.
>The white 20 pin connector would go to the control and here is where I haven't any idea how to begin to sort out what pins would go to what and what type of control to use.
>
>

The closest I've come so far is :
http://www.iis-servo.com/ToshibaPartsService.asp

Jon