CAD CAM EDM DRO - Yahoo Group Archive

Do-it-Yourselfer Looking for advice.

Posted by wanliker@a...
on 2004-03-04 09:45:00 UTC
You will find a lot of information in the FAQ, the files and links sction of
the group, addresses at the bottom of this post.
Also go to: Untitled Document http://members.cox.net/walachcnc/materials
this has a typical list of parts needed for a conversion to a mill, would also
apply to a lathe, just use two axis.
Also there are thousands of answers in the message archives. Read all of
them, and you will be an ex-spurt, and also very tired........................
bill


[Non-text portions of this message have been removed]

Discussion Thread

thazulxyz 2004-03-04 07:30:53 UTC Do-it-Yourselfer Looking for advice. wanliker@a... 2004-03-04 09:45:00 UTC Do-it-Yourselfer Looking for advice.