toshiba vfd
Posted by
Dan Quinn
on 2004-03-12 19:02:06 UTC
Anyone got any ideas on how I can slow my toshiba vfd below .5 hz. I
have updated my mill with a toshiba 3600 rpm motor and toshiba s-9
vfd. The problem I have is .5 hz.(30 rpm),if I have figured right, is
too fast to orient the spindle for a tool change in direct drive.I
have to shift to low through the back gear set up every time I make a
tool change.
Thanks
Dan Quinn
have updated my mill with a toshiba 3600 rpm motor and toshiba s-9
vfd. The problem I have is .5 hz.(30 rpm),if I have figured right, is
too fast to orient the spindle for a tool change in direct drive.I
have to shift to low through the back gear set up every time I make a
tool change.
Thanks
Dan Quinn
Discussion Thread
Dan Quinn
2004-03-12 19:02:06 UTC
toshiba vfd
Jon Elson
2004-03-12 21:10:51 UTC
Re: [CAD_CAM_EDM_DRO] toshiba vfd
Dan Quinn
2004-04-17 08:24:10 UTC
Re: [CAD_CAM_EDM_DRO] toshiba vfd
Jon Elson
2004-04-18 00:29:06 UTC
Re: [CAD_CAM_EDM_DRO] toshiba vfd