Re: [CAD_CAM_EDM_DRO] help finding rockford

----- Original Message -----
From: Fung Chen <pcfw@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Saturday, April 15, 2000 2:00 AM
Subject: Re: [CAD_CAM_EDM_DRO] help finding rockford


> Thank you for giving me the privilage of taking part
> in this interesting forum. I wish to continue but hope
> to change my email address to cadcamcenter@...
> Thanks. Peter
>
> --- ptengin@... wrote:
> > In a message dated 4/14/00 2:26:51 PM Hawaiian
> > Standard Time, JanRwl@...
> > writes:
> >
> > << << I was looking for a Ballscrew
> > Kit. Microkinetics has one for $1300. Is that
> > too High?? >>
> > What, for Bridgeport retrofit kit? Heck, no!
> > That's quite fair!
> > >>
> >
> > Let's make sure we're comparing apples with apples.
> > Some kits are precision
> > rolled, some are ground. I think most if not all
> > come with the yoke casting,
> > some may not. Only at that can we tell if a
> > particular kit is a good value or
> > not.
> >
> > Peter
> > THRD, Inc
> >
>
> __________________________________________________
> Do You Yahoo!?
> Send online invitations with Yahoo! Invites.
> http://invites.yahoo.com
>
> ------------------------------------------------------------------------
> Win $1000 at eGroups!
> Enter "$1000 Fridays" at:
> http://click.egroups.com/1/2862/2/_/423600/_/955778446/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>