Re: Lathe Ballscrew Questions/ Lagun Mill
Posted by
jdmullett
on 2004-03-22 07:01:05 UTC
Don't have a Nook Lathe but would be interested in any pointers on
converting my Lagun mill. How did you do yours? Offline reply is OK
if you prefer not polluting this thread.
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Jack Hoffa"
<jack.darlene.hoffa@a...> wrote:
converting my Lagun mill. How did you do yours? Offline reply is OK
if you prefer not polluting this thread.
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Jack Hoffa"
<jack.darlene.hoffa@a...> wrote:
> I have a Nook (Chinese)14-40 Lathe and am starting retrofit.
> I have about finished my Lagun Mill.
> 1. Do you replace the acme thread shaft or the feed shaft or just
> add the ballscrew in a new place for the Z axis?
> 2. Do you replace the cross slide acme screw or ? for the X axis?
>
> Any one who has pictures or plans I would be grateful.
>
> Thanks .... Jack Hoffa
Discussion Thread
Jack Hoffa
2004-03-22 00:08:59 UTC
Lathe Ballscrew Questions
jdmullett
2004-03-22 07:01:05 UTC
Re: Lathe Ballscrew Questions/ Lagun Mill