Re: [CAD_CAM_EDM_DRO] Engraving
Posted by
Yesamazza@a...
on 2004-04-05 18:36:07 UTC
I have engraved parts and then used a plastic scraper to remove excess paint
while it is still wet. It looks good and I haven't had trouble with it coming
off I think the fact its protected by being below the surface. Even if it
sticks lightly it will not flake out. I have also believe that there are clear
sealers you can cover the entire surface with later. Good Luck
[Non-text portions of this message have been removed]
while it is still wet. It looks good and I haven't had trouble with it coming
off I think the fact its protected by being below the surface. Even if it
sticks lightly it will not flake out. I have also believe that there are clear
sealers you can cover the entire surface with later. Good Luck
[Non-text portions of this message have been removed]
Discussion Thread
Tim Goldstein
2002-09-30 10:19:07 UTC
Re: [CAD_CAM_EDM_DRO] Engraving
glee@i...
2002-09-30 17:42:27 UTC
Re: [CAD_CAM_EDM_DRO] Engraving
Tim Goldstein
2002-09-30 23:38:15 UTC
RE: [CAD_CAM_EDM_DRO] Engraving
exeric1
2004-04-05 17:49:39 UTC
Engraving
Yesamazza@a...
2004-04-05 18:36:07 UTC
Re: [CAD_CAM_EDM_DRO] Engraving
Greg Pettengill
2004-04-05 18:45:09 UTC
Re: [CAD_CAM_EDM_DRO] Engraving
Vince Negrete
2004-04-05 19:01:04 UTC
Sherline Site FTP access?
jeffalanp
2004-04-05 22:41:33 UTC
Re: Sherline Site FTP access?
Vince Negrete
2004-04-06 00:21:22 UTC
Re: [CAD_CAM_EDM_DRO] Re: Sherline Site FTP access?
Bob McKnight
2004-04-06 03:32:57 UTC
Re: [CAD_CAM_EDM_DRO] Engraving
caudlet
2004-04-06 05:30:54 UTC
Re: Engraving
Paul
2004-04-06 06:25:34 UTC
Re: [CAD_CAM_EDM_DRO] Re: Sherline Site FTP access?
Vince Negrete
2004-04-06 07:57:59 UTC
Re: [CAD_CAM_EDM_DRO] Re: Sherline Site FTP access?
tsomer2003
2004-04-06 22:02:50 UTC
Re: Engraving
wanliker@a...
2004-12-30 12:12:52 UTC
Engraving