CAD CAM EDM DRO - Yahoo Group Archive

Re: RE brushless/small motor control

Posted by ballendo
on 2004-04-13 14:19:36 UTC
Hello,

Thank you for the link. Apparently they DO have the ability to
control up to 25 motors, as the original poster requested. Their
Ft6xx chips will do it.

Ballendo

--- In CAD_CAM_EDM_DRO@yahoogroups.com, Yesamazza@a... wrote:
> There is a site that gets little notice here because it sells
products to
> small for the power requirements of CNC milling/Lathes . They may
have some
> things of interest if your into robotics and low dollar motor
control. The company
> is Ferrettronics and they make servo controls for RC servos ect
instead off
> automation type apps. I have never used any of there products but
it seems they
> have some fun low dollar components.
> http://www.ferrettronics.com/
>
>
> [Non-text portions of this message have been removed]

Discussion Thread

Yesamazza@a... 2004-04-13 09:47:46 UTC RE brushless/small motor control ballendo 2004-04-13 14:19:36 UTC Re: RE brushless/small motor control