Sv: [CAD_CAM_EDM_DRO] Re: Driver software.
Posted by
J. J. Larsen
on 2000-04-22 11:43:12 UTC
Hi Fred.
First thanks to all for helping. Thanks.
I have downloaded a copy of DesKam and DeskNC, at first sight it looks
great, just what I needed, it could also do the PCB isolation stuff. But
when I use square pads and footprints for surface mounted devices (also
square), these pads/footprints will NOT be accepted by DesKam. Am I doing
anything wrong or is it a known problem ?
Jens J. Larsen
Denmark
First thanks to all for helping. Thanks.
I have downloaded a copy of DesKam and DeskNC, at first sight it looks
great, just what I needed, it could also do the PCB isolation stuff. But
when I use square pads and footprints for surface mounted devices (also
square), these pads/footprints will NOT be accepted by DesKam. Am I doing
anything wrong or is it a known problem ?
Jens J. Larsen
Denmark
>PS-I'm sure someone will correct me if DesKam doesn't take DXF Right?
>
>
>Best Regards,
>
>Fred Smith
>IMService
>
>imserv@...
>Phone: 248-486-3600 or 800-386-1670
>Fax:248-486-3698