Re: [CAD_CAM_EDM_DRO] Re: [Emc-users] No Torque (power?)

On Friday 21 May 2004 09:35 am, Steven Ciciora spake:

> Very good thought. See how much the voltage is dropping under load. If it
> drops significantly (more than 10% or so) then it's not up to the
> task. Could you make some voltage measurements and report back? Voltage
> of the power supply without the motors connected?

I know that without the Geckos connected, it shows 65VDC.
(what I've set it to via the Variac)
*With* the Geckos connected, it's still 65VDC.
I don't know if it drops when moving the motors,
but will check as soon as I get a chance and report back.

Thanks,

Weyland