Stepper Interface Question
Posted by
Kory Hamzeh
on 2004-05-27 17:09:40 UTC
What are the minimum signals required to control a stepper motor driver
for CNC applications? Is Step, Direction, & Ground enough or do I also
need an Enable signal? I only have two unused pins and a three pin
connector.
Regards,
Kory
for CNC applications? Is Step, Direction, & Ground enough or do I also
need an Enable signal? I only have two unused pins and a three pin
connector.
Regards,
Kory
Discussion Thread
Kory Hamzeh
2004-05-27 17:09:40 UTC
Stepper Interface Question
Robert Campbell
2004-05-27 17:14:19 UTC
Re: [CAD_CAM_EDM_DRO] Stepper Interface Question