New a3977 based controller
Posted by
afogassa
on 2004-06-09 21:20:19 UTC
Hi All,
After about two years of stop and go I've got my cnc controller
ready. It's based on the a3977 chip and deskcnc, the concept was to
build a motherboard with deskcnc built in and having all the 4 step
drives plugged onto it, so if there is a problem on one axis just
unplug the drive plug a new one and it's ready to go again.
there is also a 4 output rele board that plugs on the 5 slot.
Tomorrow I'll upload pictures of the machines I've built.
The site is mainly in portugues We are in Brasil, but there is
a english page.
I'm at http://www.maquitronic.com.br/english.htm
and Http://www.maquitronic.com.br/products.htm
If there is interest on any product, I can ship to US or any other
countries.
Thank's
Fogassa
After about two years of stop and go I've got my cnc controller
ready. It's based on the a3977 chip and deskcnc, the concept was to
build a motherboard with deskcnc built in and having all the 4 step
drives plugged onto it, so if there is a problem on one axis just
unplug the drive plug a new one and it's ready to go again.
there is also a 4 output rele board that plugs on the 5 slot.
Tomorrow I'll upload pictures of the machines I've built.
The site is mainly in portugues We are in Brasil, but there is
a english page.
I'm at http://www.maquitronic.com.br/english.htm
and Http://www.maquitronic.com.br/products.htm
If there is interest on any product, I can ship to US or any other
countries.
Thank's
Fogassa