When you can't use a vice...
Posted by
Jason Spangle
on 2004-06-24 23:00:05 UTC
Hello everyone,
I run a small toy & model engineering shop in Indiana.
My latest addition to the shop is a Minitech Mini-mill 4, been doing
good so far with this machine.
I guess my first question is what kind of double faced tape does
everyone use here? I'm looking for something that can take higher
temps, because I machine brass for my master patterns, and the
"carpet" type of tape lets go if I don't keep the brass cool enough.
The only other solution is to make a vacuum table, but it would need
to have MDF inserts that could be replaceable.
nice to meet everyone,
Jason
I run a small toy & model engineering shop in Indiana.
My latest addition to the shop is a Minitech Mini-mill 4, been doing
good so far with this machine.
I guess my first question is what kind of double faced tape does
everyone use here? I'm looking for something that can take higher
temps, because I machine brass for my master patterns, and the
"carpet" type of tape lets go if I don't keep the brass cool enough.
The only other solution is to make a vacuum table, but it would need
to have MDF inserts that could be replaceable.
nice to meet everyone,
Jason