Re: [CAD_CAM_EDM_DRO] Opinions: Cheap 3-axis Software
Posted by
Mike
on 2000-05-01 16:33:13 UTC
At 03:43 PM 5/1/00 -0600, you wrote:
Thanks for the feedback. The linux world is tempting, but the learning
curve on all this is steep enough without throwing a new operating system
into the mix. Perhaps I can get started with some cheap/free DOS based
software and graduate to the open linux stuff later?
Do you run the EMC software? I assume it's open source so if you're savvy
you can customize it?
Thanks again,
Mike
>If you are at all computer savvy and don't mind learning a little Linux ITim,
>would suggest you take a look at EMC. Start with www.linuxcnc.org
>
>It certainly qualifies from your price requirement (free) and supports
>steppers or servos.
>
>Tim
>[Denver, CO]
Thanks for the feedback. The linux world is tempting, but the learning
curve on all this is steep enough without throwing a new operating system
into the mix. Perhaps I can get started with some cheap/free DOS based
software and graduate to the open linux stuff later?
Do you run the EMC software? I assume it's open source so if you're savvy
you can customize it?
Thanks again,
Mike
>----- Original Message -----
>From: <mnels@...>
>To: <CAD_CAM_EDM_DRO@egroups.com>
>Sent: Monday, May 01, 2000 3:00 PM
>Subject: [CAD_CAM_EDM_DRO] Opinions: Cheap 3-axis Software
>
>
> > Any opinions on cheap (< $200?) Step/Direction CNC parallel port
> > software for a mini-mill? Some of the choices are:
> >
> > MaxNC's Software ($125 std & $225 deluxe)
> >
> > Supercam ($200 upgrade with a Micromill)
> >
> > Yeager CNC Pro ($175 std or $125 "lite")
> >
> > DeskNC ($60 from Camtronics)
> >
> > DANCAM
> >
> > Others?
> >
> >
Discussion Thread
Tim Goldstein
2000-05-01 14:40:45 UTC
Re: [CAD_CAM_EDM_DRO] Opinions: Cheap 3-axis Software
Mike
2000-05-01 16:33:13 UTC
Re: [CAD_CAM_EDM_DRO] Opinions: Cheap 3-axis Software
Larry Ruebush
2000-05-01 18:58:25 UTC
Re: [CAD_CAM_EDM_DRO] Opinions: Cheap 3-axis Software
Tim Goldstein
2000-05-01 19:43:49 UTC
RE: [CAD_CAM_EDM_DRO] Opinions: Cheap 3-axis Software
Charles Gallo
2000-05-01 19:56:24 UTC
Re: [CAD_CAM_EDM_DRO] Opinions: Cheap 3-axis Software
Doug Fortune
2000-05-01 21:32:54 UTC
Re: [CAD_CAM_EDM_DRO] Opinions: Cheap 3-axis Software
Jon Elson
2000-05-01 22:12:28 UTC
Re: [CAD_CAM_EDM_DRO] Opinions: Cheap 3-axis Software
Dan Falck
2000-05-13 06:02:23 UTC
linuxcnc news