need to upgrade control

Tom thanks for your reply, I have checked out all the sites
you posted over the last 6 months along with others.
www.glentek.com, www.ajaxcnc.com, www.turnertec.com
www.copleycontrols.com, http://www.geocities.com/machinemate/,
http://www.logosolinc.com/, plus a lot more.
The driver boards and the regulator board are connected to
the bandit control by a 16 pin ribbon cable, so separating them from
the old control is not a problem.
What I really need is some sort of self contained motion
control that will output a +/- 10vdc to the drivers, accept either
encoder or resolver feedback and interface with a notebook running
software that I can program in Gcode. I use a windows based program
called Shadcom to upload and download programs to the Bandit control
now, this is done thru my notebook's serial port.
I have DRO for the X Y Z axis position and another that
shows what block of code the machine is executing on the control
consul Ill have to check the prints to see where they get there input
from, maybe I can still use them.

Thanks Terry Huntington