CNC out put Analog +/- 10V signal into step/direction?
Posted by
irfan_younis
on 2004-07-29 22:05:09 UTC
Hello!
I would like to convert our CNC out put Analog +/- 10V signal into
step/direction signal and want to drive stepper motor.
Any one have any circuit for conversion of these signals or any
drawing?
regards,
Irfan
I would like to convert our CNC out put Analog +/- 10V signal into
step/direction signal and want to drive stepper motor.
Any one have any circuit for conversion of these signals or any
drawing?
regards,
Irfan