stepper conversion
Posted by
peter@x...
on 1999-06-11 13:48:13 UTC
Hello
I am new to the list and the internet,I converted a far eastern mill to stepper control about two years ago, which has run successfully since, I purchased the interface and program from R Bartlett Coventry England for �130.00 it is required to add resistors to the interface dependant on the size of stepper desired. It runs on 10v 9amps for each motor with 10TPI leadscrews, this gives a pull on the beds of 130 LB, which is adequate for my needs but I have run it at 12v for an hour or so with 155 LB pull.
Anyone requiring details of the conversion please get in touch
Peter Smith
peter@...
I am new to the list and the internet,I converted a far eastern mill to stepper control about two years ago, which has run successfully since, I purchased the interface and program from R Bartlett Coventry England for �130.00 it is required to add resistors to the interface dependant on the size of stepper desired. It runs on 10v 9amps for each motor with 10TPI leadscrews, this gives a pull on the beds of 130 LB, which is adequate for my needs but I have run it at 12v for an hour or so with 155 LB pull.
Anyone requiring details of the conversion please get in touch
Peter Smith
peter@...