swapping on resources

I just posted a note asking about someone who may want to sell an
old cnc system and I had an additional idea pop up. I design printed
circuit boards for a consumer electronics firm so the electrical
side is no problem for me but I have very few resources on the
mechanical side. I would like to extend an offer of 'services-for-
parts' to anyone who would like to have a custom controller board
made or something of that nature and might have used or extra
mechanical parts they would like to swap. Since I'm very much a
beginner in CNC I have nothing accumulated at this point so ball
screws, linear movement parts, stepper motors, bearings etc. would
all be of interest. If you've been at this for awhile you know more
about what I might need then I do.

I can provide gerbers, excellon files , etc. for single sided or
multi-layer plated thru designs. I have sources for ordering the
physical boards if you need that also.

just a thought.

ed.russell@...