CAD CAM EDM DRO - Yahoo Group Archive

Re: RE: [CAD_CAM_EDM_DRO] CAD VS Drafting Table Re: Names

Posted by wanliker@a...
on 2000-05-05 20:44:33 UTC
In a message dated 5/4/0 3:15:05 PM, wbbengtsson@... writes:

<< Assuming equal proficiency with a drawing board and a CAD system, is there
any type of drawing that is suited to the manual process, as opposed to the
CAD process? >>

drawing a straight line, more or less of an undetermined length. Have it
done before the computer boots.
grin,
bill

Discussion Thread

Fred Smith 2000-05-04 06:06:27 UTC Re: Names Wayne Bengtsson 2000-05-04 07:14:26 UTC RE: [CAD_CAM_EDM_DRO] CAD VS Drafting Table Re: Names George Potter 2000-05-04 07:31:11 UTC Re: [CAD_CAM_EDM_DRO] CAD VS Drafting Table Re: Names zeff1015@a... 2000-05-04 08:14:54 UTC Re: [CAD_CAM_EDM_DRO] CAD VS Drafting Table Re: Names Mike Mueller 2000-05-04 08:51:54 UTC RE: [CAD_CAM_EDM_DRO] CAD VS Drafting Table Re: Names A. G. Eckstein 2000-05-04 14:26:05 UTC RE: [CAD_CAM_EDM_DRO] CAD VS Drafting Table Re: Names james owens 2000-05-04 16:14:40 UTC Re: [CAD_CAM_EDM_DRO] CAD VS Drafting Table Re: Names wanliker@a... 2000-05-05 20:44:33 UTC Re: RE: [CAD_CAM_EDM_DRO] CAD VS Drafting Table Re: Names Jon Anderson 2000-05-06 09:19:14 UTC Re: [CAD_CAM_EDM_DRO] CAD VS Drafting Table Re: Names wanliker@a... 2002-04-22 09:32:43 UTC Names Paul 2002-04-22 13:06:08 UTC Re: [CAD_CAM_EDM_DRO] Names David Eldredge 2002-04-24 06:57:07 UTC Re: [CAD_CAM_EDM_DRO] Names art 2002-04-24 07:10:49 UTC Re: [CAD_CAM_EDM_DRO] Names David Eldredge 2002-04-24 07:30:50 UTC Re: [CAD_CAM_EDM_DRO] Names