CAD CAM EDM DRO - Yahoo Group Archive

Re: Nema 42 3100 oz/in motors will not move

on 2004-09-10 08:25:11 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Keith Clark" <mail@t...>
wrote:
> Where is the free TurboCNC to try? The only site I could find was
> not free and it would take time to order.
> thanks
> Keith Clark
>

http://www.dakeng.com/ is the home page. Version 4 is free to try
for 30 days or so and then is pay if you use it. Fully un-restricted
verson no cripple.


http://www.dakeng.com/


The support group is


http://groups.yahoo.com/group/turbocnc/files/REL3-DAK/

and version 3.xx is available there for those who want the smaller
version.

did you maybe google turboCAD and not turboCNC ?

Dave

Discussion Thread

Keith Clark 2004-09-09 18:55:30 UTC Nema 42 3100 oz/in motors will not move turbulatordude 2004-09-09 21:43:58 UTC Re: Nema 42 3100 oz/in motors will not move Mariss Freimanis 2004-09-09 23:02:02 UTC Re: Nema 42 3100 oz/in motors will not move Keith Clark 2004-09-10 04:47:46 UTC Re: Nema 42 3100 oz/in motors will not move Keith Clark 2004-09-10 05:21:58 UTC Re: Nema 42 3100 oz/in motors will not move Robert Williams 2004-09-10 05:42:01 UTC Re: [CAD_CAM_EDM_DRO] Re: Nema 42 3100 oz/in motors will not move turbulatordude 2004-09-10 08:25:11 UTC Re: Nema 42 3100 oz/in motors will not move Keith Clark 2004-09-10 08:50:13 UTC Re: Nema 42 3100 oz/in motors will not move pondindustrial 2004-09-10 11:42:39 UTC Re: Nema 42 3100 oz/in motors will not move turbulatordude 2004-09-10 11:46:52 UTC Re: Nema 42 - - Bridgeport Steppers Keith Clark 2004-09-12 09:30:41 UTC Re: Nema 42 3100 oz/in motors will not move