CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Motor Controler

on 2004-09-13 12:48:44 UTC
On Monday 13 September 2004 12:09 pm, Jon Elson wrote:
> Paul wrote:
> >Dave - For full six axis control, EMC handles it.
>
> Does it really? For fully independent 6-axis, such as UVWXYZ or
> ABCXYZ? I thought there were some limitations on the combinations
> of axes the interpreter would accept. I know EMC will OUTPUT
> 6 axes, as when using a hexapod.

Can one of you guys explain to me what the heck a hexapod is? I've seen that
go by in here a few times now...

Discussion Thread

T Davis 2004-09-11 16:01:12 UTC Motor Controler caudlet 2004-09-12 11:40:51 UTC Re: Motor Controler metlmunchr 2004-09-12 12:05:52 UTC Re: Motor Controler turbulatordude 2004-09-12 20:03:16 UTC Re: Motor Controler Paul 2004-09-13 00:54:26 UTC Re: [CAD_CAM_EDM_DRO] Re: Motor Controler Jon Elson 2004-09-13 09:14:33 UTC Re: [CAD_CAM_EDM_DRO] Re: Motor Controler Paul 2004-09-13 09:37:24 UTC Re: [CAD_CAM_EDM_DRO] Re: Motor Controler R Rogers 2004-09-13 11:40:45 UTC Re: [CAD_CAM_EDM_DRO] Re: Motor Controler Steve Stallings 2004-09-13 12:01:52 UTC Re: Motor Controler Roy J. Tellason 2004-09-13 12:48:44 UTC Re: [CAD_CAM_EDM_DRO] Re: Motor Controler turbulatordude 2004-09-13 13:04:45 UTC Re: Motor Controler Simon M. Arthur 2004-09-13 13:26:06 UTC Re: [CAD_CAM_EDM_DRO] Re: Motor Controler Jon Elson 2004-09-13 17:53:23 UTC Re: [CAD_CAM_EDM_DRO] Re: Motor Controler Jon Elson 2004-09-13 17:57:17 UTC Re: [CAD_CAM_EDM_DRO] Re: Motor Controler