MasterCAM post-processor for EMC???
Posted by
miguel_cubillas
on 2004-09-27 14:39:03 UTC
Hello,
Does anyone out there know if any of the standard(included)
MasterCAM post-processors will work with the Liunx based EMC
software NC controller? Better yet, does anyone know of a custom
post-processor just for EMC?
Thanks
Does anyone out there know if any of the standard(included)
MasterCAM post-processors will work with the Liunx based EMC
software NC controller? Better yet, does anyone know of a custom
post-processor just for EMC?
Thanks