Re: [CAD_CAM_EDM_DRO] Motor controller

In a message dated 11/9/2004 9:47:12 AM Mountain Standard Time,
kdoney_63021@... writes:
Also, I am assuming that this motor is a shunt wound DC since it has
5 wires (2 for armature, 2 for field and 1 ground), is this correct?

<
<
I was under tthe impression that it is a permanent magnet motor, two wires
for armature, two wires for heat sensor, and a geround wire.
So I would do some more checking.
bill


[Non-text portions of this message have been removed]