Re: [CAD_CAM_EDM_DRO] Bridgeport Easy Track Gcode
Posted by
Tom Hubin
on 2005-01-04 16:17:28 UTC
Hello Mike,
Thanx. I got the 2 page PDF listing. I can see immediately that my CW
helix is a problem. Some interpreters use G02 and some use G72.
Bridgeport uses G12. I would never have figured that out without the
list that you sent to me.
I need to track down more info though, just to make sure that parameters
and usage are correct. So I am still looking for a manual or maybe
several pages explaining Bridgeport's preferences for Gcode and Mcode
usage.
In particular, Bridgeport's method for comments is not known to me. Some
interpreters start a comment with a semicolon. Some interpreters enclose
comments within parentheses. What method does Bridgeport use?
Tom Hubin
thubin@...
*************************************
Mike Gann wrote:
Thanx. I got the 2 page PDF listing. I can see immediately that my CW
helix is a problem. Some interpreters use G02 and some use G72.
Bridgeport uses G12. I would never have figured that out without the
list that you sent to me.
I need to track down more info though, just to make sure that parameters
and usage are correct. So I am still looking for a manual or maybe
several pages explaining Bridgeport's preferences for Gcode and Mcode
usage.
In particular, Bridgeport's method for comments is not known to me. Some
interpreters start a comment with a semicolon. Some interpreters enclose
comments within parentheses. What method does Bridgeport use?
Tom Hubin
thubin@...
*************************************
Mike Gann wrote:
>*************************
> Hi Tom -
>
> I think I have a PDF list of these.
> I will email them to you off list.
>
> Mike Gann
> -----Original Message-----
> From: Tom Hubin [mailto:thubin@...]
> Sent: Tuesday, January 04, 2005 10:32 AM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: [CAD_CAM_EDM_DRO] Bridgeport Easy Track Gcode
>
> Hello,
>
> A friend has a Bridgeport mill with Easy Track controller for X and Y
> axes. He will CNC the Z axis if we can get this all to work in 2d first.
>
> He has a manual but does not have much info on gCodes. We tried to run
> stuff that I do with TurboCnc on my Sherline mill. Easy Track loaded and
> ran my Gcode then objected to some Gcode or format but would not say to
> what specifically.
>
> Where can I get a list of Gcodes that Bridgeport likes?
>
> Tom Hubin
> thubin@...
Discussion Thread
Tom Hubin
2005-01-04 10:31:19 UTC
Bridgeport Easy Track Gcode
Mike Gann
2005-01-04 10:36:07 UTC
RE: [CAD_CAM_EDM_DRO] Bridgeport Easy Track Gcode
Tom Hubin
2005-01-04 16:17:28 UTC
Re: [CAD_CAM_EDM_DRO] Bridgeport Easy Track Gcode
Mike Gann
2005-01-04 19:40:32 UTC
Re: [CAD_CAM_EDM_DRO] Bridgeport Easy Track Gcode