Anilam Series M
Posted by
Don Chandler
on 2005-01-04 19:06:45 UTC
I used to have a M control. It was a great controller. Sold the machine and bought a new machine with a new Anilam 4 axis control. It is OK, but does have some strange quirks.
I downloaded and uploaded to the series M with a serial cable. I started doing it with Waynemark Integrator in Dos. Later with Bobcad and with Vector from Windows. I don't remember any of the details, but I can tell you that when you find the right combination of wires in the serial cable it works well. I always had great results calling Anilam. Haven't had to call them in a while. Good Luck!
Don
[Non-text portions of this message have been removed]
I downloaded and uploaded to the series M with a serial cable. I started doing it with Waynemark Integrator in Dos. Later with Bobcad and with Vector from Windows. I don't remember any of the details, but I can tell you that when you find the right combination of wires in the serial cable it works well. I always had great results calling Anilam. Haven't had to call them in a while. Good Luck!
Don
[Non-text portions of this message have been removed]