CAD CAM EDM DRO - Yahoo Group Archive

Re: Motion Controller?? Sorry, Try Again

Posted by Ron Ginger
on 2005-01-31 15:20:29 UTC
>So let me restate what I don't understand. I need
>recommendations on what components are needed to
>convert Mach2's output to pulses that will go to my
>Geckos.

You dont NEED anything- the output of Mach2 is to a parallel port and it
can be connected directly to the Gecko drive inputs.

However, you might WANT to add a breakout board in between for reasons
of signal isolation, ease of wiring and the charge pump safety circuit.
I use the PMDX breakout board and find it very good. There are others.

The term 'motion controller' often refers to the device that does the
real time signal generation. There are system that use various motion
controller boxes that are sent a high level command from the PC and in
turn generate the steps. Mach doesnt do that. DeskCNC and Flashcut have
proprietary montion control boards.

ron ginger

Discussion Thread

Daniel T. Medlin 2005-01-31 13:13:28 UTC Motion Controller?? Sorry, Try Again Steve Stallings 2005-01-31 13:22:05 UTC Re: Motion Controller?? Sorry, Try Again Stephen Wille Padnos 2005-01-31 13:26:52 UTC Re: [CAD_CAM_EDM_DRO] Motion Controller?? Sorry, Try Again turbulatordude 2005-01-31 13:46:35 UTC Re: Motion Controller?? Sorry, Try Again Ron Ginger 2005-01-31 15:20:29 UTC Re: Motion Controller?? Sorry, Try Again turbulatordude 2005-01-31 17:07:16 UTC Re: Motion Controller?? Sorry, Try Again