new page up on linuxcnc.org
Posted by
Dan Falck
on 2000-05-27 16:15:14 UTC
EMC users,
Ray Henry has written another section for the handbook at www.linuxcnc.org.
It's a how-to on setting up the emc *.ini file. This should be helpful to
anyone who has had problems getting out of e-stop.
Go to : http://www.linuxcnc.org/install/emcinst.htm
This page is under the sub heading of "Initialization File".
Thanks again Ray!
Dan
Ray Henry has written another section for the handbook at www.linuxcnc.org.
It's a how-to on setting up the emc *.ini file. This should be helpful to
anyone who has had problems getting out of e-stop.
Go to : http://www.linuxcnc.org/install/emcinst.htm
This page is under the sub heading of "Initialization File".
Thanks again Ray!
Dan