Re: counting encoder holes ?
Posted by
cnc_4_me
on 2005-02-12 15:36:59 UTC
> Gnd is (I assume on the ground plane) on pin 4 so I assume pwr ison
> pin 8.One trick is to look for a electrolitic cap on the board and look for
>
pwr and ground going to it.
Wally
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "turbulatordude"
<dave_mucha@y...> wrote:
><eexgs@n...>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "Graham Stabler"
> wrote:times
> >
> > That's right, you have two edges on each pulse and two sets of
> pulse
> > trains. So the number of pulses per inch or revolution is 4
> > the number of lines per inch/revolution.on
> >
> > Graham
>
> Great, at least it is something I can use.
>
> Any ideas on how to figure the voltage, or should I assume it is 5
> volts?
>
>
> The main IC is one I cnnot identify. it is a National Semi, 8 pin
> DIP with M8528. I can't seem to cross reference that number.
>
> My main interest, of course, is to connect 5v and ground properly.
>
> Gnd is (I assume on the ground plane) on pin 4 so I assume pwr is
> pin 8.
>
> Anyone have a book that would cross reference this chip ?
>
> Dave
Discussion Thread
turbulatordude
2005-02-12 09:43:19 UTC
counting encoder holes ?
Graham Stabler
2005-02-12 12:58:07 UTC
Re: counting encoder holes ?
turbulatordude
2005-02-12 14:18:08 UTC
Re: counting encoder holes ?
cnc_4_me
2005-02-12 15:36:59 UTC
Re: counting encoder holes ?
Jon Elson
2005-02-12 22:11:30 UTC
Re: [CAD_CAM_EDM_DRO] Re: counting encoder holes ?
turbulatordude
2005-02-13 07:24:23 UTC
Re: counting encoder holes ? BEST encoder range ?
braidmeister
2005-02-13 07:39:36 UTC
Re: counting encoder holes ? BEST encoder range ?
cnc_4_me
2005-02-13 09:17:53 UTC
Re: counting encoder holes ? BEST encoder range ?
Jon Elson
2005-02-13 11:01:58 UTC
Re: [CAD_CAM_EDM_DRO] Re: counting encoder holes ? BEST encoder range ?
turbulatordude
2005-02-13 11:44:15 UTC
Re: counting encoder holes ? BEST encoder range ?
braidmeister
2005-02-13 11:58:03 UTC
Re: counting encoder holes ? BEST encoder range ?