CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Spindle Encoder For Lathe

Posted by Drew Rogge
on 2005-02-14 11:47:45 UTC
Glad to help. Are you using this with TurboCNC? The reason I ask
is that I found out about this board over on the TurboCNC Yahoo
group. Don't know if you know about the group but you might want
to check it out.

Drew

lathehand_2 wrote:
>
>
> Drew, Thats what I had in mind, Thanks, I sent an e-mail to him and
> waiting on an answer. Great Job!
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, Drew Rogge <drew@p...> wrote:
>
>>Probably not as bolt on as you want but here's a listing for
>>a board:
>>
>>http://www.cnc4pc.com/Index_Pulse_Card.htm
>>
>>lathehand_2 wrote:
>>
>>>Hello Everyone,
>>>I need to find a Spindle Encoder for my Lathe. I need an would
>
> prefer
>
>>>a complete unit that can be just bolted on. I need a 1 pulse per
>>>Rev.and does anyone have any direction as to where I might find
>>>something that I can use. (I can't build for the reason of a
>>>disability), and would be just a waste of time and material. Want
>
> to
>
>>>run with TCNC Hook Up. Any Help is more than Welcomed. Thanks.
>>>
>>>
>

Discussion Thread

lathehand_2 2005-02-14 08:09:23 UTC Spindle Encoder For Lathe Drew Rogge 2005-02-14 08:33:56 UTC Re: [CAD_CAM_EDM_DRO] Spindle Encoder For Lathe turbulatordude 2005-02-14 08:34:47 UTC Re: Spindle Encoder For Lathe lathehand_2 2005-02-14 11:28:58 UTC Re: Spindle Encoder For Lathe Drew Rogge 2005-02-14 11:47:45 UTC Re: [CAD_CAM_EDM_DRO] Re: Spindle Encoder For Lathe