I'm new here
Posted by
scott3d3@a...
on 2000-06-02 08:15:36 UTC
I've been in the moldmaking trade for over 20 years. I draw with
Cadkey and program with Bobcad, hopefully my knowledge in the field
can be of service to someone out there. And hopefully someone can
help me with a problem I have with an older MX3 mill reading Bobcad
programs when I do 3D work. The MX3 reads in events, meaning I have
to have a start XYZ and end XYZ on every line. If I were to DNC
directly to my mill would this cure my problem. I would hate to
purchase the cable and find out it don't work. Thank you Scott Warden.
Cadkey and program with Bobcad, hopefully my knowledge in the field
can be of service to someone out there. And hopefully someone can
help me with a problem I have with an older MX3 mill reading Bobcad
programs when I do 3D work. The MX3 reads in events, meaning I have
to have a start XYZ and end XYZ on every line. If I were to DNC
directly to my mill would this cure my problem. I would hate to
purchase the cable and find out it don't work. Thank you Scott Warden.