Re: wtb: Dynapath Delta series 20 main board

Gregg, are you sure you can just swap the main board? There was a
discussion about 10's vs 20's on the Practical Machinist board a week
or so ago. One of the members there is a former Dynapath field
engineer and he mentioned that the main difference from the 10 to the
20 is that the 20 is a dual processor control where one processor
controls machining and the other takes care of all auxiliary
functions. Just thought I'd mention this. I have no idea myself, but
it would seem unusual if such a major change is available via a simple
board swap. If you're interested, here's the thread at PM, and I'd
imagine 6handicap over there can tell you most anything you happen to
need, including sources for boards.

http://www.practicalmachinist.com/ubb/ultimatebb.php?ubb=get_topic;f=13;t=000994

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "g_verstraten"
<g_verstraten@y...> wrote:

>
>
> I need a main board for a dynapath 20, to upgrade my dynapath 10 so I
> can drip feed large programs. Ne1? Thanks! Gregg