Re: [CAD_CAM_EDM_DRO] Older wide carriage printer servo motors
Posted by
Jon Elson
on 2005-03-23 17:52:02 UTC
Meyclan wrote:
mini-mill retrofit. Mine have a 10 conductor ribbon cable and 10 contact
IDC connector crimped onto them. Pin 1 is A, 5 and 6 are ground, 9 is
+ 5 V, and pin 8 is B.
Jon
>The Servo motors I have are made by Hathaway and are 100oz/inch.These may be out of a Calcomp plotter. I have these motors on a
>Do you have any iformation on the decoders?
>
>
mini-mill retrofit. Mine have a 10 conductor ribbon cable and 10 contact
IDC connector crimped onto them. Pin 1 is A, 5 and 6 are ground, 9 is
+ 5 V, and pin 8 is B.
Jon
Discussion Thread
callcbmf
2005-03-22 15:36:28 UTC
Older wide carriage printer servo motors
Meyclan
2005-03-23 12:24:49 UTC
Re: [CAD_CAM_EDM_DRO] Older wide carriage printer servo motors
Jon Elson
2005-03-23 17:52:02 UTC
Re: [CAD_CAM_EDM_DRO] Older wide carriage printer servo motors
Rolf Nilsen
2005-03-23 20:07:17 UTC
Re Older wide carriage printer servo motors