RE: [CAD_CAM_EDM_DRO] ringing steppers

Scott -

It's hard to figure out what your replying to if you don't include just a
little snippet at least.

Carlos Guillermo
VERVE Engineering & Design

> -----Original Message-----
> From: scott3d3@... [mailto:scott3d3@...]
> Sent: Tuesday, June 06, 2000 8:37 AM
> To: CAD_CAM_EDM_DRO@egroups.com
> Subject: Re: [CAD_CAM_EDM_DRO] ringing steppers
>
>
> After looking it over I'm not sure, but there should be an
> address from where
> it's from, block that address. Hope it helps, Scott.
>